Missed Spot Polyurethane Floor

The dull and shiny spots in your hardwood floor indicate that your installers did not apply the finish correctly.

Missed spot polyurethane floor.

Sand the area clean it with a solvent afterwards denatured alcohol apply polyurethane let dry. There s a sheen difference on the missed spots but the color is consistent. Typically two to three coats are used with sanding in between coats to even them out. Missed spots in polyurethane on hardwood floor.

How can i fix this without compounding the problem. Using a good quality polyurethane and a china bristle brush and three differ. The process is straightforward. Missed a spot applying poly.

This is how to polyurethane a spot on the floor with that refinishing the floor. Hardwood floors add a warm and natural glow to any room. The part i missed is pretty evident in the correct light. Can i just add some polyurethane coating to the missed spots or is that going to cause an issue.

I am using minwax super fast drying clear satin. When it comes to finishing furniture or hardwood floors polyurethane is the key to protecting and preserving the stain. I tried touching it up by rolling on some poly but the finish is matte and somewhat cloudy from. Focus on that one small area and ignore the rest of the floor.

I m wondering how long this coat will really last given it wasn t sanded first. With a little tender loving care they can keep their soft shine for years. Spot refinishing hardwood floors. Once the finish is dry you can do minor repairs and that s easier than repairing a big area of overworked finish.

I have had repairs done on oak floors that resulted in refinishing small areas. I assume that you have a polyurethane floor so i will base my answer on that. But even the most careful. Dull spots in polyurethane floors usually indicate that the finish was not applied carefully the applicator had a dry spot on it or the finish was thinned out with a solvent such as mineral spirits.

It looks remarkably good. Use solvent based polyurethane and get the same finish type gloss satin etc and apply a few thick coats. I put a final coat of polyurethane on my wood floors and noticed that i missed a spot where my roller didn t overlap in application after the floor completely dried. If you see a small puddle or a spot you missed 6 feet out don t touch it.